ATTENTION!
If you already have USB-Emulator for MC X4 (HASP or NetHASP)  installed you can skip steps 1) - 5) and need only to run "mastercam_X5_crk.exe"

1) Unpack a folders "USB-Emul_Win64" and  "remove_old_emuls"  to your computer

2) Run "remove_old_emuls\delete_old_emuls.bat"  to CLEAR a Windows Registry from "blacklisted" Emulators

3) Run "mcamX4_MU3-dealer-nethasp.reg" or "mcamX4_MU3-industrial-nethasp.reg" (dealer dump has got extended functionality!) if you want to install Mastercam X5 with NetHASP SIM type.
	or
run "mcamX4_MU3-dealer_hasp.reg" if you want to install Mastercam X5 with HASP SIM type.


4) Install a USB-Win64 Emulator

You need a local Administrator rights to install this emulator for Win64!
On Windows Vista64 and Windows7 64-bit you need to boot Windows in mode F8 > Desable Unsigned Drivers Enforcment !!!

4.1. Reboot computer (for Windows Vista64 and Windows7 64-bit you need to boot Windows in mode F8 > Desable Unsigned Drivers Enforcment !!!)
4.2.   Install usb-emulator drivers
  Start ->  Control Panel -> Add Hardware (Yes, I have already connected the hardware) -> Add a new hardware device -> Install the hardware that I manually select from a list -> Show all Devices -> Have disk -> Browse -> (browse to folder "USB-Emul_Win64") -> OK -> Confirm to install not certificated drivers if Windows ask for..

If setup is succesfull you have to see new system device:
Device Manager -> System devices -> Virtual Usb Bus Enumerator


5)  Install MC X5 as HASP or NetHASP SIM type. 

6) Copy Mastercam.exe from crack to <Mastercam X5 progdir> and replace original one

7) Enjoy

